Tuning hoverbike transmission and engine control automation

We completed the assembly of our prototype .

The hoverbike transmission has been assembled. Manufactured the engine control automation (governer) and started its tuning.

During the test, a faulty coupling was detected so we purchased and installed a new one. Now we are adjusting the variable pitch screw drives.

Hits: 19

One Response

  1. Gary Dale Phillips says:

    How did you set up your transmission. Did you use beveled gears. Im building some thing simular here and really would like to know how your transmission is built. Im wanting to use 5206 bearings on mine.

Leave a Reply

Your email address will not be published. Required fields are marked *